Plastic injection mould , coolant passages, eject pin and electrical heating holes.

塑胶射出模具?冷却水孔 、 射梢孔及电热孔.

互联网

Plastic injection mould - coolant passages, eject pin and electrical heating holes.

塑胶射出模具 - 冷却水孔 、 射梢孔及电热孔.

互联网

The injection mould for a duplicator cover plate is designed.

设计了复印机盖板的注塑模具.

互联网

This thesis deals with the design of injection mould of plastic.

论述塑料制品的注塑模设计.

互联网

The practical injection mould structure design for lampshade was presented.

给出了灯罩注塑模实用结构.

互联网

Key words: hose - connect 、 injection mould 、 take off whorl 、 side core.

关键词: 软管接头、注射模、脱螺纹、侧向抽芯.

互联网

The general design principle of gas assisted injection mould design is discussed.

阐述了气体辅助注射模具设计的一般原则,介绍了气针的工作原理和选择方法.

互联网

The injection mould parting line and its sequence as sizing space split were described.

主要阐述了注射模的分型面以及它的顺序、定距分型.

互联网

The structural design and operating process of an injection mould for the part were introduced.

分析了电熨斗大身的工艺特点,介绍了电熨斗大身注射模结构设计和工作过程.

互联网

This paper is about a Computer Aided Design for Plastics Injection mould cooling waterway.

介绍了塑料注射模具冷却水道的计算机辅助设计.

互联网

Chosen the mobile phone cover paper introduced the method of the injection mould design.

本文以手机前盖注塑模具设计为例,介绍了常用注塑模具设计方法和流程.

互联网

The development method of injection mould standard part database management system is discussed in theis paper.

本文介绍了注塑模具标准件数据库管理系统的开发方法.

互联网

The injection mould design of pressure head is introduced, and the points of design also elaborated.

对押头注塑模设计的实例介绍, 详细阐述了其中的设计要点.

互联网

A method of automatic generation of feature - based injection mould core & cavity is put forward.

提出基于特征的注射模具型 芯 型腔自动创建的实现方法.

互联网

The construction, function and basic principle of computer simulation system for injection mould were introduced.

简要介绍了注射成型过程计算机模拟系统的组成 、 功能及主要技术原理.

互联网